Menu
Your Cart

PS Composites

Liquid Latex
In Stock
Brand: PS Composites
Latex is a natural air drying liquid rubber easily used to produce thin skinned, highly elastic moulds. A former (original model) is simply dipped into the liquid latex. A thin film of latex will cling to the former, and dipping is repeated until a skin of the required thickness is built up. Imm..
8.00€
Brand: PS Composites
Progel retarder is a retarding component for slowing down the working and de-moulding times of our Pro-Gel systems and also addition cure silicones by adding as little as 1 % by weight.100 gr..
15.00€
Brand: PS Composites
Allows control of the hardness of Shore 10 HT silicones - Required for the good realization of silicone prostheses used in cinema...
40.00€
Brand: PS Composites
By mixing Softener to the two-part Pro-Gel 10 system at a ratio of anywhere from 30-120%, you can soften the silicone to give it the feel of human skin...
40.00€
Brand: PS Composites
A two part hand-mixing foam, perfect for applications which require a soft sponge-like result.Possesses an excellent skin in a closed mould. Mix ratio 2-1 by weight...
54.00€
Brand: PS Composites
A spray that is used for spraying into fibre-glass before pouring addition silicones. It forms a barrier to stop the inhibition of the silicone.Can also be used to seal wet-clay sculptures to prevent moisture inhibiting the moulding material.  ..
20.00€
Brand: PS Composites
Snap Sil is a pre-thickened silicone with two-component platinum treatment. The mixture is made at 1: 1 and its hardness is 22. Its working time is 5 minutes and the demolding takes place in 15/30 minutes...
182.00€
Brand: PS Composites
PS Thixo Addative is an additive which can be added to any condensation cure silicone at approximately two percent by weight. It turns silicone into a paste, allowing you to creat great brush on silicones on to vertical surfaces.100 gr..
14.00€
ZA 22
Out Of Stock
Brand: PS Composites
ZA 22 Silicone Fluid is a bi-component silicone which vulcanizes at room temperature. Since it is fairly fluid, it is recommended for duplicating complex models. It is also very flexible and resistant. The working time is approximately 15 min and the demold time after about 1 hour at room temperatur..
78.00€
Showing 1 to 10 of 10 (1 Pages)